The 18650 Battery Charge Holder V3 0.5A USB Type-A Charging Protection Board is compatible for Arduino, Raspberry Pi,esp8266 or Sensors with protection. The output current can reach upto 2A. This 18650 Battery Holder/Development Board is compatible With Raspberry Pi3B/3B that comes with a built-in battery charging module as well as an I2C battery monitoring system for the raspberry pi. If you want to convert your project into a portable solution then this is a solution for you this board comes with a 18650 Li-ion Battery holder and a charging module for the battery this board can supply a maximum of up to 6A current to the raspberry pi via its output terminals which is more than enough for the normal operation of the raspberry pi. This module has a built-in battery monitoring system, which can monitor the battery voltage and send the information via the I2C protocol to the raspberry pi. This can come in handy while building a self-powered raspberry pi project which can also monitor the battery voltage and alert when the battery voltage falls below a certain limit. Features: This module is suitable for 18650 battery only over-charging protection and over-discharge protection Micro USB port Charging Input A type USB Output Charge current: 0.5A 1 switches to control the USB output Input voltage: 5 ~ 8V Three 3V 1A output interface Three 5V 2A output interface LED light, green for full of charge, red for under charging Follow the direction “ ” “-” on the PCB Specifications: Operating Voltage (VDC): 5 Max. Output Current (A): 6 Length (mm): 100 Width (mm): 30 Height (mm): 30 Weight (gm): 10 Note: This module is suitable for 18650 battery only This module can be powered or for raspberry pi and sensor at the same time This module output current up to 2A (This product does not contain 18650 battery installation, be careful of the battery positive and negative when install, do not reverse. Please follow the – direction on the PCB and do not follow the positive and negative directions on the battery holder) Package Includes: 1 x 18650 Battery Charge Holder 0.5A USB Charging Protection Board
